Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
GRILLE REMOVAL (MODELS 660)
Screwdriver required.
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grille.
1. To release the Front Grille, remove the
3 screws on the back of the inlet grille,
located at roughly 10, 2 and 6 o'clock
positions.
2. Dust or wash Front Grille with a mild
Screw
dishwashing soap. Do not place grille in
the dishwasher. The excessive heat can
distort the plastic.
3. To reattach - position the Front Grille
so the Vornado logo in the center of the
Front Grille is straight. Replace all the
screws.
Use the brush attachment on your household
vacuum cleaner to vacuum any accumulated
dust off the Front Grille and Air Inlets.
12 English
Screw
Note: The motor
is permanently
lubricated and
requires no oiling.
Screw
CLEANING
BLADE REMOVAL
Pliers recommended.
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing blade.
1. First, remove the nut from the shaft
by turning the nut clockwise to
loosen. Remove the washer. Pull the
blade straight out from the shaft.
2. Wipe the Blade with a damp cloth.
If your circulator is used in a greasy
environment, such as a kitchen,
mild soap or a common household
Remove Nut
cleaner may be necessary. Do not
Clockwise
use solvents. Do not place blade in
the dishwasher. The excessive heat
can distort the plastic.
3. To reattach - be certain the flat
side of the shaft aligns directly with
the corresponding flat side on the
blade's socket. Push the blade all
the way on the shaft until it bottoms
out. Do not use a hammer as this
could result in bearing damage.
Reinstall nut.
13
English
Publicidad
