Sauder Worksense MASON PEAK Serie Manual Del Usuario página 20

Step 15
å
Carefully turn your unit onto its front edges, and fasten the BRACE (O) to the ENDS (A and B). Tighten two HIDDEN CAMS.
å
Diagram #1 - Unfold the BACKS (N) and lay them into the lower edges of the ENDS (A and B).
å
Diagram #2 - Fasten the lower BACK (N) to the BRACE (O). Use five CLIPS (67G) and five BLACK 9/16" LARGE HEAD
SCREWS (1S) into the pre-drilled holes in the BRACE (O).
å
NOTE: The CLIPS should wrap around the edge of the BACK and the teeth of the CLIPS should bite into the BRACE as
you tighten the screws.
å
To fasten the top edge of the upper BACK (N), place the OFFSET EDGE of the Nail Holder down against the top of your
unit 1-1/2" from the corner. Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into
back edge of the TOP. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish
fastening the BACK to the TOP with the hammer and Nail Holder evenly spacing eight NAILS along the edge.
Nail Holder
Nail slot
Offset edge
A
Tighten both HIDDEN
CAMS in the BRACE (O)
before fastening the BACK.
Page 20
The top edge of the
upper BACK should
be even with the TOP.
N
427809
N
O
2.
67G
N
O
BLACK 9/16" LARGE HEAD SCREW
(5 used in this step)
1
1N
NAIL
(8 used in this step)
B
Lower edge
1.
1S
www.sauder.com/officeservice