Sauder Worksense MASON PEAK Serie Manual Del Usuario página 26

Step 21
å
With someone's help, center your HUTCH onto the base unit of your choice.
å
Fasten the BRACKET CONNECTORS (81G) to the ENDS (A and B). Use four SILVER 1" LARGE HEAD SCREWS (102S).
å
NOTE: There are no pre-drilled holes in the 427805 or 427807 for attaching the HUTCH. You will need to drill 1/8" wide,
1" deep holes through the open holes in the BRACKET CONNECTORS (81G).
å
Fasten the HUTCH to the base unit using the newly drilled holes. Use four SILVER 1" LARGE HEAD SCREWS (102S)
through the BRACKET CONNECTORS and into the base unit.
Caution
Two person
lift required
1st - Fasten the BRACKET
CONNECTORS to your HUTCH.
81G
2 - Mark and drill 1/8" holes
nd
through the holes in the BRACKET
CONNECTORS and into the base unit.
Page 26
A
81G
427809
SILVER 1" LARGE HEAD SCREW
(8 used in this step)
81G
www.sauder.com/officeservice
102S
B