ZANKER KITN323K Manual De Instrucciones página 93

The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
5.3 The heat setting
Touch to increase the heat setting. Touch
to decrease the heat setting. Touch
and at the same time to deactivate the
cooking zone.
5.4 OptiHeat Control (3 step Residual
heat indicator)
WARNING!
/ / As long as the indicator is
on, there is a risk of burns from residual
heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators appear when a cooking zone
is hot. They show the level of the residual
heat for the cooking zones you are currently
using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
The hob deacti‐
vates after
6 hours
5 hours
4 hours
1.5 hour
5.5 PowerBoost
This function makes more power available to
the induction cooking zones. The function can
be activated for the induction cooking zone
only for a limited period of time. After this time
the induction cooking zone automatically sets
back to the highest heat setting.
Refer to "Technical data" chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: touch
5.6 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking zone,
then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function or change the
time: touch or
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash, the time
counts down.
To see the remaining time: touch
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To deactivate the function: touch
the cooking zone and then touch
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an
acoustic signal sounds and 00 flashes.
The cooking zone deactivates.
To stop the sound: touch
• Minute Minder
You can use this function when the hob is
activated and the cooking zones do not
operate. The heat setting display shows
comes on.
or
of the timer to set the
to set
to set
. The
.
ENGLISH
.
.
93