ZANKER KITN323K Manual De Instrucciones página 98

Problem
The heat setting changes be‐
tween two levels.
The control panel becomes
hot to the touch.
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
9. TECHNICAL DATA
9.1 Rating plate
Model KITN323K
Typ 61 A2A 00 AA
Induction 3.65 kW
Ser.Nr. .................
ZANKER
98 ENGLISH
Possible cause
Power management operates.
The cookware is too large or you
put it too close to the control pan‐
el.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the
zone.
There is an error in the hob.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 492 566 00
220 - 240 V, 50 - 60 Hz
Made in: Romania
3.65 kW
Remedy
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.