Tennant T300e Manual Del Operario página 19

CHARGING BATTERIES
The charging instructions in this manual are intended
for the battery charger supplied with your machine. The
use of other battery chargers that are not supplied and
approved by Tennant are prohibited.
If your machine is equipped with an off-board battery
charger refer to the charger's owners manual for
operating instructions. Contact distributor or Tennant
for battery charger recommendations if machine is not
equipped with charger.
FOR SAFETY: The use of incompatible battery
chargers may damage battery packs and
potentially cause a fire hazard.
IMPORTANT NOTICE: The supplied off- board battery
charger is factory set to charge Trojan WET lead- acid
batteries. If machine is equipped with a different battery
type (i.e. AGM, etc.), the charger settings MUST be
changed to prevent battery damage.
To change the off- board battery charger settings, refer
to the off-board charger's owner manual.
1. Transport the machine to a well-ventilated area.
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and open
flame away when charging.
2. Park the machine on a flat, dry surface, turn off
machine and remove key.
FOR SAFETY: When servicing batteries, stop on
level surface, turn off machine and remove key.
3. If the machine is equipped with flooded (wet) lead-
acid batteries check the battery electrolyte level
weekly before charging. See FLOODED (WET)
LEAD-ACID BATTERIES.
Tennant T300e (07- 2022)
4. For models equipped with off-board chargers, first
connect the charger's DC cord into the machine's
battery charge receptacle then plug the AC power
supply cord into a properly grounded wall outlet
(Figure 42).
FOR SAFETY: Do not disconnect the off-board
charger's DC cord from the machine's receptacle
when the charger is operating. Arcing may result. If
the charger must be interrupted during charging,
disconnect the AC power supply cord first.
5. The charger will automatically begin charging until
fully charged. The maximum charging cycle may
take up to 6- 12 hours depending on battery type.
6. After charging batteries always disconnect the AC
power supply cord first before disconnecting
charger from machine.
English
EN
FIG. 42
19