Tennant T300e Manual Del Operario página 11

MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE-OPERATION CHECK LIST
- Sweep area and remove any obstructions.
- Check brushes/pads for wear and damage.
- Check squeegee blades for wear and damage.
- Confirm recovery tank empty and screen and
debris tray is clean.
- Check scrub head skirt for wear and damage.
- Check machine for proper operation.
OPERATING MACHINE
1. Turn the key to the on ( I ) position.
2. Lower the scrub head to the floor by stepping on
the scrub head lift pedal as shown (Figure 11).
3. Lower the squeegee assembly to floor by stepping
on foot pad as shown (Figure 12). To raise
squeegee assembly, place toe under foot pad and
lift. The vacuum motor will start when squeegee
assembly is lowered.
Tennant T300e (07- 2022)
FIG. 11
FIG. 12
4. To begin scrubbing, pull the start bail (Figure 13).
Slowly push the machine forward. The rotating
brush will help assist the machine forward.
5. To adjust the solution flow rate when scrubbing,
turn the solution flow control knob located
underneath machine (Figure 14).
6. To stop scrubbing, release the start bail and raise
the scrub head and squeegee assembly off floor.
Turn key off .
WHILE OPERATING MACHINE
WARNING: Flammable materials materials or
reactive metals can cause an explosion or fire. Do
not pick up.
1. Overlap each scrub path by 2 inches (5 cm).
2. Keep machine moving to prevent damage to floor
finish.
3. Wipe squeegee blades with a cloth if blades leave
streaks.
4. Avoid bumping the machine into posts and walls.
FOR SAFETY: When operating machine, do not
scrub on inclines that exceed 9% grade or
transport on inclines that exceed 21% grade.
5. Pour a recommended foam control solution into the
recovery tank if excessive foam appears.
ATTENTION: Foam buildup will not activate the
float shut-off screen, vacuum motor damage will
result.
English
EN
FIG. 13
FIG. 14
11