Publicidad
Idiomas disponibles
Idiomas disponibles
EN
PARTS LIST
(see "Items Supplied" on page 2)
Item.
No..
Description
1
1
Barbecue unit (preassembled)
2
1
Warming rack
3
2
Grill rack, large (34.5 x 41.5 cm)
4
1
Grill rack, small (21.5 x 41.5 cm)
5
5
Flame tamer
6
1
Bin
7
1
Bin side table
8
1
Side panel, left
9B
1
Support, back left
9A
1
Support, front left
10
4
Connecting piece
11
2
Door handle
12
2
Base plate
13
1
Magnet
14
1
Gas cylinder holder 1
15
1
Gas cylinder holder 2
16A
1
Support, front right
16B
1
Support, back right
17
1
Back panel
18
1
Base cabinet door, left
19
1
Base cabinet door, right
20
1
Base cabinet panel
21
1
Grease pan, large
22
1
Grease tray
23
2
Wheel
24
1
Wheel axle
25
2
Hubcap
26
1
Side panel, right
27
1
Angle fitting
28
1
Grease pan, small
29
1
Side burner
30
1
Side burner grill rack
1
Screw set with assembly materials
Please Note!
■ Check the items supplied for completeness and the components
for transport damage. If any parts are missing or damaged,
contact the customer service department (see last page).
■ Remove any films, stickers or transport protection from the
device, but never the rating plate and possible warnings!
■ Keep plastic bags and films away from young children
and animals! There is a danger of suffocation.
6
GG-IV-510_AM_de_LM_V1.indb 6
GG-IV-510_AM_de_LM_V1.indb 6
NOTICES FOR ASSEMBLY
■ Ensure there is sufficient space to assemble the device and if
necessary use a mat to protect the device or delicate floors from
being scratched.
■ Assemble the device on a horizontal, flat surface to make sure it
is straight.
■ Follow the assembly steps shown in these assembly instructions.
■ Do not apply any force when assembling the device.
■ First tighten the screw connections so they are hand-tight and
then tighten them again properly once you have completed the
assembly step.
■ Tighten the nuts until they fit firmly, and then turn them a quar-
ter turn more. Do not tighten them too hard!
■ You will find all the other information about the device in the
operating instructions that are also supplied. Before you use
the device for the first time, please read through the op-
erating instructions carefully!
FUNCTIONAL ELEMENTS
A
A A A
D
E
A Main burner control knob
B Side burner control knob
C Electronic ignition knob
D On/Off button for the LED light
E Battery compartment for the LED light
INSERTING THE BATTERY OF THE
ELECTRONIC IGNITION
Before the device is first used, a 1.5 V battery (AA, not supplied with
the device) must be inserted into the electronic ignition:
Unscrew the electronic ignition knob (C) anticlockwise and insert
the battery or replace it if necessary. Pay attention to the correct
polarity (+/-). Screw the knob back on.
A
C
B
11.11.2021 14:08:24
11.11.2021 14:08:24
Publicidad
