Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRIMING INSTRUCTIONS
1. After cartridge or bulk loading of the grease
gun, carefully release plunger handle from the
slot in the end cap (In case of Filler Pump Load-
ing, plunger rod is already free from the slot).
2. Engage plunger rod with the follower by ro-
tating the plunger handle. Move plunger rod
back and forth into the grease barrel to force
out any trapped air.
3. Disengage plunger rod from the follower by
rotating the plunger handle. Push the plunger
rod into the grease barrel. Wipe the Automatic
Air Bleeder to make it free of any blockage or
debris.
4. Press the grease gun switch until the gun
starts dispensing grease.
MAINTENANCE
1. BEFORE PERFORMING ANY MAINTENANCE
OR WHEN STORING THE GREASE GUN, ensure
the Switch is in the "OFF" position, Battery is
removed from the Grease Gun and the Charger
is unplugged from its electrical outlet.
2. BEFORE EACH USE, check for misalignment,
damage, noise or binding of moving parts,
leaking Battery Pack, damaged Hose, and any
other hazardous condition.
3. Do not use a defective equipment unless the
fault is rectified.
4. Never burn Batteries, as they can explode in
a fire. Do not charge leaking batteries. Contact
local solid waste authorities for instructions
on correct disposal or recycling of the Battery
Pack.
5. Use a soft, dry cloth, remove all dirt, grease,
and debris from the exterior of the Grease
Gun. Do not use solvents to clean the Grease
Gun.
6. Keep the Grease Gun and its accessories in a
clean, dry location and out of children reach.
GREASING A GREASE FITTING (GREASE NIPPLE)
1. The grease coupler provided at the end of
the grease gun hose has a jaw type construc-
tion. The coupler jaws will snap on to a grease
fitting and maintain a tight fit.
2. When connecting the coupler to the grease
fitting, press the coupler straight onto the
grease fitting to form a snug fit. Start operat-
ing the grease gun with the coupler as square
to the grease fitting as possible.
E N G L I S H •
To engage,
push straight on
3. Once greasing is completed, slightly tilt the
coupler, twist and pull back. The tilt and twist
action will allow easy removal of the coupler
from the grease fitting.
TROUBLESHOOTING
GREASE LEAKING FORM PRESSURE RELEASE
VALVE
Back Pressure more than 6,000 PSI: Do not use
gun for this application.
GREASE GUN NOT WORKING
Battery not charged: Charge the battery and
then use.
Battery not installed properly: Take out bat-
tery and reinstall correctly.
BATTERY NOT CHARGING
Battery charger not connected to Power Sour-
ce: Connect battery charger properly.
Battery not fixed properly in the charger: Take
out battery from the charger and fix again.
TECHNICAL DATA
BATTERY
CHARGER INPUT
CHARGER OUTPUT
GREASE CONTAINER
GREASE DELIVER
WORKING PRESSURE
WEIGHT
U se r's m a nua l
To remove,
Tilt, Twist
& Pull
19,2 V
120 V ~ 60 Hz
19,2 V
1,5 Ah
500 cc
85 g (3 oz)
586 bar (8 500 PSI)
7,4 kg (16,3 lb)
13
Publicidad
Tabla de contenido
