ExecutiveSafe ES035 Manual De Usuario página 5

Turning the keypad sound on and off
The keypad sound can be turned OFF and ON by pressing the "CLEAR" button when the safe is
in the sleep mode in other words the display is turned off.
The display will show "SOUND ON" or "SOUND OF"
Alarm Function
Note: For the alarm to be activated, the alarm function must be set every time the safe is
locked. In case the alarm function is not set and the safe is moved or jarred or an attempted
forced entry occurs the alarm will not be activated.
To set the alarm function, close the door, and make sure the safe is in the sleep mode, press the
"0" button, the display will Show "BELL ON", indicating that the alarm has been activated.
If the alarm function is set and the safe experiences severe vibration, the alarm will be activated
for 30 seconds.
The alarm can be deactivated by entering the correct finger print or by pressing the "LOCK"
button for the keypad to wake up and entering the correct combination followed by the "LOCK"
button.
Lockout Function
If the wrong combination or a wrong finger print is entered five consecutive times, the display
will show ERROR each time the wrong combination is entered, and at the fifth incorrect entry the
display will show HOLD and start counting from 210 down to 0 and the alarm will be activated
for 30 seconds. The keypad and the finger recognition scanner will enter a 210 second lock out
period. During this period the keypad and the finger recognition scanner will be disabled. After
the 3.5-minute lock out period the keypad and the finger recognition will become active again.