ExecutiveSafe ES035 Manual De Usuario página 7

Programming the Safe
❖
For your safety, please program the combination and at least one finger before
start using the safe.
❖
The safe is shipped with a preset combination: 159
❖
To restore the above factory settings of the safe at any time, press and hold the
push button located at the back of the door, inside the battery compartment, for
more than 3 seconds up until two beebs are emitted. See Fig. 3.
Fig. 3
Programming the Combination
With the safe door open, press and release the button located at the back of the door, in the battery
compartment, see Fig. 3. One beep is emitted and the fingerprint scanner and the display are
flashing.
Enter the new combination consisting of 3 to 8 digits followed by the "LOCK" button. The new
combination is successfully programmed. You can now operate the safe with your new
combination. The old combination is erased.
Programming the Finger Print
With the safe door open, press and release the button located at the back of the door, in the battery
compartment, see Fig. 3. One beep is emitted and the fingerprint scanner and the display are
flashing.
Place your finger on the fingerprint scanner until you hear a beep, remove your finger and repeat
the same finger scanning two more times. The last time you will hear 2 short beeps and the
scanner flashes twice indicating that the new finger print is registered and saved. You can now
operate the safe with your registered finger print.
To program more finger prints repeat the same process again.
Test the new combination or fingerprint with the door open.
Note: 100 finger prints can be programmed. When the red light flashes on the finger recognition
scanner 10 times and the beep sounds 10 times this is an indication that the fingerprint register is
full. To delete the finger prints and program new ones press and hold the push button located at
the back of the door, in the battery compartment, for more than 3 seconds up until two beebs are
emitted. See Fig. 3. The combination is now 159.
Program again the combination and program again the desired fingerprints.