Helite Airbag e-GP AIR Manual De Instrucciones página 37

CAUTION
The description of the LEDs and beeps below only applies to you if you use the
road mode with an optional SDU fork sensor.
Pairing in progress
The LED turns blue + 1 beep
every 5 s. during 30 s.
Pairing successful
The LED turns blue + 1 long
beep for 2 s.
Pairing active
The LED turns blue + 2 beeps.
Pairing failed
The LED turns red + 4 beeps.
8. SERVICING AND MAINTENANCE
a) Washing the airbag vest
Please follow these instructions to avoid damage to the airbag vest. The airbag
vest is made of leather, please use suitable products for its care. Do not machine
wash, do not wash by hand, do not immerse in water or dry clean. The only way
to clean the airbag vest is with a soft cloth slightly soaked in soap. Do not use
detergents or bleach. We recommend that you dry them on a hanger in a dry place.
Do not put it in the dryer, on a radiator or near a heat source. Do not iron.
b) Annual e-cartridge check
We recommend an annual check of the weight and condition of the cartridge. The
airbag vest must be switched off. Unplug the cartridge and unscrew it. Weigh the
cartridge on an accurate kitchen scale. Make sure the weight of the cartridge is
within +/- 3 grams (e-60 cc) of the weight indicated on the cartridge label. Check
the appearance of the cartridge: connector wire in good condition, no corrosion, no
dents. If nothing to report, reinstall the cartridge (see page 33). If you encounter
any problems, contact your dealer or Helite Customer Service at sav@helite.com.
c) Duration of life of the airbag vest
The airbag vest does not have a maximum number of inflations or a limited
duration of life. It all depends on the conditions of use and maintenance. Even if the
airbag vest is functioning properly, we recommend that you have it serviced every
year after its first use. To have the airbag serviced, please contact your dealer or the
Helite customer service department at sav@helite.com.
You have 30 s. to place the
magnet over the SDU fork
sensor.
The airbag vest and the SDU
fork sensor are now paired.
The airbag vest and the SDU
fork sensor are correctly paired.
Repeat the pairing procedure
or delete all the SDU fork
sensors already paired.
37