Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SET UP & USE
INSTALLATION STEPS
NOTE: All set screws must be checked and retightened where necessary, before and
after installation.
1. MOUNTING OPTION
A. DOWNROD MOUNT
•
Using a Philips screwdriver, loosen the two upper jam screws on the yoke.
•
Position downrod inside canopy.
•
Route wires exiting yoke on motor through ceiling canopy and downrod.
•
Position downrod/canopy into yoke and align holes between yoke and downrod.
•
Insert bolt through the aligned openings between yoke and downrod. Be careful
not to damage or cut the fan wires.
•
Tighten flat washer, lock washer, and nut and bolt (not included on some
models). Secure with cotter pin through hole in the end of the bolt.
•
Secure downrod in position by tightening upper jam screws.
Fig.2a
Flat
Washer
Jam
Screw
Fig.2c
Page 8
Cotter Pin
CAUTION
Yoke
Jam
Screw
Do not loosen two
lower jam screws
Fig.2b
Bolt
Cotter
Pin
Yoke
Flat
Washer
Bolt
Publicidad
