Publicidad
Step 1
å
IMPORTANT: Because of the edges of some parts before assembly may be sharp, please handle
unassembled parts carefully.
å
Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
å
Fasten the BRACES (D and E) to the CUSHION (A) as shown in the diagram. Tighten six 1-3/8" HEX
HEAD SCREWS (1) using the L-WRENCH (3).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
425211
3
D
www.sauder.com/service
1
1-3/8" HEX HEAD SCREW
(6 used in this step)
D
E
A
Page 3
Publicidad
