Publicidad
Step 12
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the HINGES on the DOOR (G) to the RIGHT END (B)
å
as shown in the lower diagram. Use four SILVER 1/2" PAN
HEAD SCREWS (9).
NOTE: You should start each SCREW a few turns before
å
completely tightening any of them.
Peel a BUMPER from the BUMPER CARD (5) and stick
å
it on the DOOR (G) where it comes into contact with
the UPRIGHT (C).
See the next step for DOOR adjustments.
å
425833
C
SILVER 1/2" PAN HEAD SCREW
(4 used in this step)
www.sauder.com/service
Stop
Mounting
screw
Hinge
B
G
9
5
Page 17
Publicidad
