Sony HT-A3000 Manual De Instrucciones página 46

Power
The speaker system does not power
up.
 Check that the AC power cord (mains
lead) is connected securely.
 Disconnect the AC power cord (mains
lead) from the wall outlet (mains), and
then reconnect after several minutes.
The speaker system does not turn
on even when the TV is turned on.
 Set
[Setup] - [Advanced Settings]
- [HDMI Settings] - [Control for HDMI]
to [On]. The TV must support the
Control for HDMI function (page 38).
For details, refer to the operating
instructions of your TV.
 Check the speaker settings of the TV.
The speaker system power syncs with
the speaker settings of the TV. For
details, refer to the operating
instructions of your TV.
 Depending on the TV, if the sound
was output from the speakers of the
TV the previous time, the speaker
system may not turn on by
interlocking with the TV power even
when the TV is turned on.
The speaker system turns off when
the TV is turned off.
 Check the setting of
[Advanced Settings] - [HDMI Settings]
- [Standby Linked to TV]. When
[Standby Linked to TV] is set to [On] or
[Auto], the speaker system turns off
automatically when you turn off the
TV.
The speaker system does not turn
off even when the TV is turned off.
 Check the setting of
[Advanced Settings] - [HDMI Settings]
- [Standby Linked to TV]. To turn the
speaker system off automatically,
regardless of the input when you turn
off the TV, set [Standby Linked to TV]
to [On]. The TV must support the
Control for HDMI function (page 38).
46
US
The speaker system cannot be
turned off.
 The speaker system may be in demo
There is no picture or the picture is
not output correctly.
 Select the appropriate input
 When there is no picture while the TV
 Disconnect an HDMI cable, then
The picture on the TV screen is
distorted.
 Interference of the wireless function
[Setup] -
 There is an interference of the
[Setup] -
The speaker system cannot connect
to a TV with the BLUETOOTH
function.
 When you connect the speaker
For details, refer to the operating
instructions of your TV.
mode. To cancel demo mode, reset
the speaker system. Press and hold 
(power) and – (volume) on the bar
speaker for more than 5 seconds
(page 52).
Picture
(page 23).
input is selected, select the TV
channel that you want using the TV
remote control.
connect it again. Make sure that the
cable is firmly inserted.
between the TV/other wireless
devices and the speaker system may
have occurred. Install the speaker
system far away from the TV/other
wireless devices.
frequency band between the wireless
LAN and the wireless connection of
the optional speakers. Switch the
band of the wireless LAN connection
of the TV or device that is playing an
image to 2.4 GHz.
Sound
system and TV with an HDMI cable,