Sony HT-A3000 Manual De Instrucciones página 47

the BLUETOOTH connection is
canceled.
No TV sound is output from the
speaker system.
 Check the type and connection of an
HDMI cable, TV center speaker mode
cable, or optical digital cable that is
connected to the speaker system and
the TV (page 17).
 Disconnect the cables that are
connected to the TV and the speaker
system, then connect them firmly
again. Disconnect the AC power cords
(mains leads) of the TV and the
speaker system from the AC outlets
(mains), then connect them again.
 When the speaker system and TV are
connected with an HDMI cable, check
the following.
– The HDMI jack of the connected TV is
labeled with "eARC" or "ARC."
– The Control for HDMI function of the
TV is set to on.
– The eARC or ARC function of the TV
is enabled.
– The number of connected devices
that can be controlled by the Control
for HDMI function has not exceeded
the limit.
– On the speaker system,
- [Advanced Settings] - [HDMI
Settings] - [Control for HDMI] is set
to [On] and
Settings] - [HDMI Settings] - [TV
Audio Input Mode] is set to [Auto].
 If your TV is not compatible with
eARC, set [Setup] - [Advanced
Settings] - [HDMI Settings] - [eARC] to
[Off].
 If your TV is not compatible with eARC
or ARC, connect an optical digital
cable (page 17). If the TV is not
compatible with eARC or ARC, TV
sound will not be output from the
speaker system even if the speaker
system is connected to the TV's HDMI
IN jack.
 Switch the input of the speaker
system to the TV input.
[Setup]
[Setup] - [Advanced
 Increase the volume on the speaker
system or cancel muting.
 Depending on the order in which you
turn on the TV and the speaker
system, the speaker system may be
muted and [MUTING] is displayed on
the front panel display of the speaker
system. If this happens, turn on the TV
first, then the speaker system.
 Press TV/AUDIO SYSTEM on the
remote control to switch the output
for the connected TV sound or set the
speakers setting of your TV to Audio
System. Refer to the operating
instructions of your TV regarding how
to set the TV.
The sound is output from both the
speaker system and TV.
 Mute the sound of the speaker system
or TV.
 When you connect the speaker
system and TV with the TV center
speaker mode cable and set
[Setup] - [Advanced Settings] -
[Speaker Settings] - [TV Center
Speaker Settings] - [TV Center Speaker
Mode] to [On], the center part of the
speaker system sound is output from
the TV. For detail, refer to Help Guide.
The TV sound from this speaker
system lags behind the image.
 Set the adjustment value of the delay
between the picture and sound to 0
msec if it is set to the range between
25 msec and 300 msec. For details,
refer to Help Guide.
 A time gap between the sound and
picture may occur depending on the
sound source. If your TV has a
function that delays the image, use it
for adjustment. For details, refer to
the operating instructions of your TV.
No sound or only a very low-level
sound of the device connected to
the speaker system is heard.
 Press  (volume) + on the remote
control and check the volume level
(page 12).
47
US