Publicidad
Idiomas disponibles
Idiomas disponibles
puncHing SHeet MetAL, cutting cABLeS, cRiMping cABLe LugS
The hydraulic connections and the sockets for the foot switch for operating e.g. the SKP-1 hydraulic
cylinder for punching sheet metal (itm. no. 02120) or for external cylinders for cutting cables or for
crimping cable lugs are located on the front of the equipment trolley.
The hydraulic hoses must be connected to the tool using a quick-release coupling, and started using the
foot switch.
please note that these tools do not have a limit switch.
MAintenAnce And inSpection
The user is obliged to maintain and care for the "4-station processing trolley" in accordance with the
information in the operating instructions and in accordance with the country-specific standards and rules.
The maintenance intervals are classified according to their recommended frequency.
Attention!
!
when the device is powered up, a risk of starting exists, e.g. by accidentally pressing the foot
switch and thus a risk of injury exists when in the vicinity of equipment components.
• Before carrying out any maintenance or repair work, ensure that the device has been
unplugged from the mains to prevent it from starting up accidentally.
Before every use...
• Visually check the complete device and foot switch for damage.
• Check all electrical and hydraulic connection lines for damage.
• Check that the hydraulic couplings are correctly and securely seated.
• Check the correct function of the foot switch.
once after 50 hours of operation...
• Complete oil change with 3 litres of HLP 46 hydraulic oil.
weekly...
• Clean the entire device. Do not use any aggressive cleaning agents to avoid damaging the safety
instructions on the device.
• Blow out the knife and anvil from the outside with dry compressed air.
• Lightly grease the outside of the knife and anvil with universal grease.
• Lightly oil the punches and dies.
note:
A missing protective film or excessive downtime of the device can lead to corrosion and thus to
impairment of the function of the components.
• Check the correct function of the safety shutdown on the protective cover and foot switch.
• Check the correct function of the emergency stop switch of the device when the pump is activated.
Boom with SKP1 cylinder
Diode socket for foot switch
Hydraulic connection with quick coupling
25
Publicidad
