Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SHARPENER ASSEMBLY
Perform two 8-10 mm holes on the
workbench, 85mm apart from one
another and 60mm from the edge
of the workbench.
GRINDING WHEEL COVER
COVER SCREWS
ADJUSTABLE
BASE
BASE LOCK
60
mm
WHEEL
When installing the sharpener on a
workbench, make sure that the lock
wheel (plastic wheel with metal nut
inside) is accessible.
Bolt the unit directly to the
workbench with two screws and
nuts (not included).
GRINDING WHEEL'S
MOUNTING
Unscrew the two screws on the disc
protection.
Remove the protection.
Unscrew the disc clamping nut.
Place the disc on the spindle,
centering it on the existing part in it.
GRINDING WHEEL'S LOCKING NUT
10
Tighten the plastic nut previously
removed.
Mount the protection and secure it
with screws.
HOW TO USE
Thoroughly clean the chain you
want to sharpen.
Secure the chain in the sliding
guides.
CUTTING
WIDTH
ADJUSTER
SLIDING
GUIDES
FASTEN WITH
SCREW AND
NUT
SLIDING GUIDES
ADJUSTER
Adjust the spacing of the sliding
guides in order to have the minimum
clearance for the chain to slide
effortlessly.
Lower the chain stop. This will
lock the chain in the tooth to be
sharpened.
Unscrew the fastener of the
adjustable base.
Place the base in the angle you
want to sharpen and tighten the
fastener.
Adjust the sharpening width
adjuster to the value you want.
Pull the sharpener body in the
direction of the chain. Adjust the
depth of tuner to the depth you want
to sharpen. You will only make this
operation once at the beginning of
each chain.
CHAIN STOP
Place the handle of the tuner of the
sliding guides in order to easily hold
before and release after sharpen
every tooth.
Insert protective goggles.
Connect the sharpening to the
electrical current (230V). Press
the switch to the "I".
CHAIN
To start sharpening the first tooth
of the chain, gently press the body
of the sharpener against it. Note:
For a good sharpening, the contact
between the grinding wheel and
the tooth should be gradual and
smooth. Do not keep the grinding
wheel for a long time sharpening the
same tooth.
If you need to make some
adjustment, turn off the machine
before.
When you finish sharpening the
first tooth of the chain switch off
the machine by pressing the switch
to "0".
Position the next tooth to sharpen,
DEPTH
ADJUSTER
SWITCH
Publicidad
