Hkoenig nv700 Manual De Instrucciones página 15

2. Pour water into the water reservoir using the measuring cup and the funnel supplied.
3. Screw the reservoir cap back into the device.
Use
•
Never aim steam directly at people, animals or plants. This can cause severe scalding.
•
Only ever hold the device by the handle and not by the attachment while operating the
device as it can become very hot. There is a danger of scalding!
•
Always work with sufficient lighting.
•
Make sure that you do not trip over the mains cable while using the device.
•
Never use the device without water!
•
Never use the device on cold glass surfaces or at outside temperatures of below 10 °C.
The hot steam could cause the glass to shatter.
•
Always try cleaning first at a small, inconspicuous spot.
•
Never direct the steam at one spot for too long.
•
The water reservoir must not be opened during use!
•
The device has a safeguard (13) which blocks the steam trigger (15) so that it cannot
be pressed accidentally. To (de)activate the safeguard, push in the securing pin.
•
Water may emerge from the attachment when you first start using it. This is normal and
does not constitute a defect with the device.
•
As the pipe in the device has to fill with steam, you may need to press the steam trigger
(16) several times when you start using it before steam starts emerging.
•
How much steam is emitted depends mainly on the speed and frequency with which the
steam trigger (15) is pressed. The faster you press it, the more steam is emitted.
However, this is at the expense of the temperature.
1. Attach the attachment you want to the device (see the "Mounting the Accessories"
chapter).
2. Insert the mains plug into a properly installed mains socket that is easily accessible.
Steam starts to be generated and the control lamp (17) lights up.
3. Wait until the control lamp goes out. Operating temperature has then been reached and
you can start steam-cleaning: Press the steam trigger (15) and move the attachment
over the surface to be cleaned as you do so.
If the steam trigger cannot be pressed, the safeguard (13) has probably been
activated. Push in the securing pin to release the safeguard.