Hkoenig nv700 Manual De Instrucciones página 16

4. If the control lamp lights up, the temperature has dropped. Let go of the steam trigger
and only press it again once the control lamp has gone out.
5. If the water reservoir is empty, steam will no longer be produced. If you want to top up
the water in the reservoir (see the "Filling the Water Reservoir" chapter) or want to stop
working, pull the mains plug out of the plug socket and allow the device to cool down
completely. Keep pressing the steam trigger if necessary until no more steam emerges
from the device. The water reservoir can then be opened.
6. Empty and clean the water reservoir each time after you use the device (see below)
to prevent deposits in the reservoir and thus damage to the device!
After Use / Cleaning the Device
Empty and clean the water reservoir each time
•
after you use the device to prevent deposits in
the reservoir and thus damage to the device!
The water reservoir cannot be opened while
•
it is pressurised. Pull out the mains plug and
keep pressing the steam trigger until no
more steam emerges from the device. The
reservoir cap can then be screwed off.
Always pull the mains plug out of the plug
•
socket when you are not using the device,
before you open the water reservoir or remove
an attachment.
The attachment and the water in the reservoir
•
may still be hot shortly after use. You should
therefore wait until they have completely
cooled
attachment or empty the water reservoir.
Never immerse the device in water or other
•
down before you remove the