Mobicool P24 DC Instrucciones De Uso página 11

_P24_P28_S25_DC.book Seite 11 Dienstag, 21. April 2009 1:55 13
All manuals and user guides at all-guides.com
P24 DC, P28 DC, S25 DC
5.3 Using the battery monitor
(Only on versions with the additional ABS feature)
Caution!
a
If you operate your cooler with the 220-240 V AC mains supply
(with rectifier accessory), switch off the battery monitor.
➤ Push the switch (fig. 3 2, page 4) on the operating panel to "ON" to
switch on the battery monitor.
✓ The red LED (fig. 3 1, page 4) on the operating panel displays the status
of the battery monitor:
Operating display Operating mode
LED glows
LED flashes
➤ Push the switch (fig. 3 2, page 4) on the operating panel to "OFF" to
switch off the battery monitor.
5.4 Changing the lid
(Only on versions with the additional insulating lid feature)
As an alternative to the unit lid, you can use an insulating lid when transport-
ing the cooler.
➤ Fold the handle of the cooler forwards.
➤ Open the lid until it is vertical and then remove it by lifting it upwards.
➤ Place the insulating lid with the guide lugs into the slots on the cooler.
Note
I
Remember that the lid is only suitable for keeping cool and not for
active cooling.
5.5 Connecting to a cigarette lighter
Note
I
If you connect the device to the cigarette lighter of your vehicle,
remember that the ignition must be turned on to supply the device
with power.
The switch-on voltage (13.1 V ± 0.2 V) is present
and the cooler is in operation.
The switch-off voltage (11.7 V ± 0.2 V) has been
reached and the battery monitor has switched off
the cooler.
Operation
11