Melchioni Family LAVIK Manual De Instrucciones página 18

1) Base
2) Bottom tube
3) Fixed screw
4) Upper tube
5) Fixed shaft sleeve
6) Fixed spacer
7) Button located
8) Fixed axis
ASSEMBLY WITH STAND
Before each use, check that the appliance is in good condition and that the power cable is not
damaged: if the power cable is damaged, it must be replaced by the manufacturer or its
technical assistance service or in any case by a qualified person. similar, in order to prevent
any risk.
1. Place the fixed product holder on the
heater with a 5 * 12 screw.
2. Insert the fixed shaft into the hole in the
pipe, then insert them into the sleeve of the
fixed shaft and the fixed spacer respectively.
3. Put the heater which is installed on the
fixed holder into the fixed shaft according to
step 2, and both sides lock with the knob
positioned
17