Melchioni Family LAVIK Manual De Instrucciones página 19

WALL MOUNTING
After adjusting the symmetrical distance of
the side on the heater holder, lock the 5 *
12 screw on the fixed holder.
1) There are 4 brackets and fasteners
used with the heater. In addition,
there are 4 25 × 25 mm square fixing
washers in the groove on the back of
the heater.
Loosen the square washers (Pic.7.1)
and fix 2 brackets to the groove on the
back of the heater with the help of
screws (Pic.7.2.)
2) Fix the brackets at the appropriate
distance from each other (45-55 cm)
(Pic. 8)
3) Two more brackets are fixed with the
help of fasteners at the appropriate
distance on the wall parallel to the
floor (At least 1.8 m from the floor
and at least 0.5 m from the ceiling).
(Pic. 5).
18