Publicidad
Idiomas disponibles
Idiomas disponibles
Release the ON/OFF button; the device
stops.
NOTE - Keep the device in a vertical position
until the desired result is achieved, without
exceeding the maximum operating time (1
minute).
Unplug the appliance from the mains.
Detach the blade holder and bottle from the
base motor by turning it counterclockwise
to the unlocked position.
TROUBLESHOOTING
Problem
The appliance does not
work after turning the ON/
OFF button.
During operation, there is a
slight burning smell.
The device switches off
during operation.
Blades do not rotate.
The bottle leaks.
14
Unscrew the blade holder from the bottle.
Be careful when handling the blade holder,
they are sharp and can cause injury.
You can conserve the mixture by screwing
the cap onto the bottle and using the
opening for easy access to the contents.
ATTENTION – Do not start the appliance
with an empty or overfilled bottle, as this
could damage the motor.
ATTENTION: The operating time must never
exceed 1 minute.
cause
The appliance is not
plugged into the mains.
The blade assembly is not
correctly connected to the
cup.
First uses.
Base motor is overloaded.
Motor overheating.
Poor appliance assembly.
Pieces too big.
Poor appliance assembly.
www.flama.pt
solution
Connect the appliance to
the mains.
Follow the instructions in
the Use chapter.
It is a normal situation,
which will disappear after
the first few uses.
Respect the quantities
indicated.
Unplug the appliance from
the mains and wait 30
minutes before plugging it
in again.
Follow the instructions in
the Use chapter.
Cut the ingredients into
smaller pieces.
Follow the instructions in
the Use chapter.
Publicidad
