Publicidad
Idiomas disponibles
Idiomas disponibles
Important!
Please note when programming all references to press = to press once and then
immediately release the button.
The earpiece of the handset may attract small ferromagnetic objects such as staples and pins,
care should be taken when placing the handset near these items.
Connection/Basic setting
1. Connect the curly cord to the handset and to the socket marked
on the side of the telephone.
2. Install the batteries. Please refer to Batteries below regarding the
installation of batteries.
3. The display should flash the word ENGLISH. If not press and hold
for approximately 4 seconds.
v
4. Select the desired language using
5. Select the desired contrast setting (2=normal) using
6. Set the hour (00-23) using
7. Set the minute using
8. Set the day using
9. Set the month using
10. Ensure the correct dialling method is displayed (ie: TONE). Press
11. Ensure the correct Recall time is displayed (ie: 100 for EU/UK/AUS,
300 France/Portugal and 600 New Zeeland.. Press
12. Connect the telephone line cord to the socket marked
back of the telephone, and then to a network wall socket.
13. Lift the handset and listen for the dial tone.
Change the clock, language or contrast settings
If you wish to change the clock, language or contrast settings at a later date,
press and hold
v
above.
Batteries
Four good quality AA batteries must be installed.
When the batteries are running low
1. Disconnect the telephone line cord.
2. On the underside of the telephone carefully remove the battery cover.
3. Insert the batteries ensuring correct battery polarity is observed.
4. Replace the battery cover.
5. Reconnect the telephone line cord.
v
/
. Press
v
V
/
. Press
v
V
/
. Press
v
V
for approximately 4 seconds and repeat steps 4. - 11.
English
/
. Press
v
V
/
. Press
.
V
0
.
0
.
0
.
0
will be displayed.
.
0
/
. Press
v
V
.
0
on the
T
q
.
0
.
0
Publicidad
