Descargar Imprimir esta página

Sunbeam GCSBCL-417-000 Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety instructions should always
be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THE STEAM IRON.
1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
2. Use appliance only for its intended use.
3. To reduce the risk of electric shock, do not immerse the appliance in
water or other liquids.
4. Always turn the appliance to "Off" before plugging or unplugging the
appliance from the electrical outlet. Never yank cord to disconnect from
outlet; instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces. Let appliance cool completely
before putting away. Loop cord loosely around appliance when storing.
6. Make sure unit is off, unplugged and allow it to cool completely before
filling or cleaning.
7. Always disconnect appliance from electrical outlet when filling with water
or emptying, and when not in use.
8. Do not operate appliance with a damaged cord, or if the appliance has
been dropped or damaged. To reduce the risk of electric shock, do not
disassemble or attempt to repair the appliance, take it to a qualified
service center for examination and repair. Incorrect reassembly or repair
could cause a risk of fire, electric shock, or injury to persons when the
appliance is used.
9. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
10. Children should be supervised to ensure that they do not play with the
appliance.
11. Burns could occur from touching hot metal parts, hot water, or steam.
Use caution when you turn a steam appliance upside down – there may
be hot water in the reservoir.
12. To reduce the risk of contact with hot water emitting from steam vents,
check appliance before each use by holding it away from body and
operating steam button.
GCSBCL-417-000_20ESM1 (US).indd 2-3
-2-
13. To reduce the likelihood of circuit overload, do not operate another high
wattage appliance from the same outlet.
14. If an extension cord is absolutely necessary, a cord with an ampere rating
equal to or greater than the maximum rating of the iron shall be used.
A cord rated for less amperage can result in a risk of fire or electric shock
due to overheating. Care shall be taken to arrange the cord so that it
cannot be pulled or be tripped over.
15. When filling the water tank, watch for water that can drip onto the floor
and cause you to slip and fall.
16. Appliance may cause personal injury or be damaged if dropped.
17. The use of attachments not recommended or sold by the appliance
manufacturer may cause injuries or void your warranty.
18. To avoid personal injury and damage to the appliance, only add water to
the water tank. NEVER add cleaning solutions, perfumes, oils or any other
chemical additives.
19. Care should be taken when using the appliance due to the emission of
steam.
20. Do not set the iron on an unprotected surface, even if it is on the heel rest.
21. The iron must not be left unattended while it is connected to the supply
mains.
22. The plug must be removed from the socket-outlet before the water
reservoir is filled with water.
23. The filling aperture must not be opened during use. Instructions for the
safe refilling of the water reservoir must be followed.
24. The iron must be used and rested on a stable surface.
25. When placing the iron on its stand, ensure that the surface on which the
stand is placed is stable.
26. The iron is not to be used if it has been dropped, if there are visible signs
of damage or if it is leaking.
27. If the iron is not operating normally, disconnect from power supply and
have the iron serviced by an authorized service center.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
-3-
10/26/20 4:19 PM

Publicidad

loading