JAROLIFT TDRC08W Instrucciones Originales página 18

PROGRAMMEREN
For setting the end positions of the controlled radio-control actuator and for further settings or programming steps, you need
the operating instructions of the respective radio-control actuator or external radio-control receiver!
INITIAL PROGRAMMING TDRC08W / TDRC02W
The example shown is exemplary and depends on the type of receiver concerned.
Please consult the receiver's operating instructions!
NOTE!
Each key must be pressed for approx. 1 second!
Each programming step must be carried out within approx. 10 seconds.
Otherwise, the system automatically exits the programming mode. If necessary, start again from the
beginning.
1. Select the desired channel with the K3 button.
2. Set the desired radio receiver or radio motor in the programming mode according to the corresponding instructions.
3. Press the up and down buttons of the wall transmitter simultaneously within approximately 10 seconds.
4. Then immediately press the stop button on the wall transmitter.
5. A successful teach-in is confirmed by a brief vibration of the tube motor connected to the radio receiver or by the vibration
of the radio motor.
Desired channel
with the K1 or K3
buttons Select
channel.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the wall-mounted transmitter.
If the motor rotation direction is incorrect (roller shutter/motor moves downwards when the UP button is pres-
sed), the motor rotation direction must be changed.
Refer to the "Changing the direction of rotation" chapter of the respective radio motor or radio receiver.
18
Set the radio recei-
ver to programming
mode.
(see instructions for
radio receiver)
Up and down button
simultaneously press.
Press the stop button. Motor vibrates.
Wall transmitter
M
is taught-in.