JAROLIFT TDRC08W Instrucciones Originales página 21

SINGLE AND GROUP OPERATION - TDRC08W / TDRC16W
The example shown is exemplary and depends on the respective receiver type. Please refer to
the instructions of the receiver!
SINGLE OPERATION
Select the desired channel or motor using the K1 and K3 keys (for key description, see page 5).
Briefly press the up, stop or down button to control the motor.
Taught-in transmitter:
Select a taught-in chan-
nel with the K1 or K3
button.
GROUP CONTROL (group operation)
1. Press and hold button K2 on the wall transmitter for approx. two seconds to activate the "Group control" mode.
activate the "Group control" mode.
2. The currently selected channel flashes in the upper left corner of the display.
3. Use the K1 and K3 keys to select the desired channel for the "group".
4. Press K2 briefly to add the desired (selected) channel to the group.
- The channel is marked with a square in the display.
Taught-in transmitter:
Press key K2 for
approx. 2 seconds
(keep pressed).
for each additional
1 2 3 4 5 6 7 8
Selected / added
channel is highl-
ighted.
Use the Up, Down
and Stop buttons
to control the
motor.
02
Currently active Select the desired
channel flashes channel with the K2 and
(e.g. channel 2).
Proceed with each
channel from the
channel added
to the group to
channel from the
be added to the
group, select the
group, according
to the same
principle.
and K3 and then
briefly press the K2
Briefly press key
K2 press - desired
K3 keys.
To remove a
If you are satisfied with
group again
To remove a
down button to exit the
group assignment. exit.
channel to be
You can now control the
deleted with K1
group you have created
button.
PROGRAMMING
M
Add desired
channel.
your settings
press the up, stop or
using the operating
buttons.
21