Fanimation CCK8534 Instrucciones De Instalación página 2

1. After removing your kit from the
packaging, use slight pressure to push
down and remove the screw trim cover
ring from the ceiling canopy assembly.
Set Screws and
Locking Nuts (2)
4. Remove the two set screws and
locking nuts from the downrod support
of the motor assembly.
7. Align the three holes in the ceiling
canopy to motor assembly and secure
using the previously removed screws in
Step 5.
Slotted
2. Separate the ceiling bracket from the
ceiling canopy by loosening the two
canopy-to-bracket screws where the
canopy is slotted and completely remove
the other two screws and retain screws
for later.
Motor
Coupler
5. Remove the three motor coupler
screws from the motor assembly and
retain the screws for Step 7.
Outlet Box
Ceiling
Bracket
8. Using the two screws and washers,
securely attach the ceiling bracket to the
outlet box, making sure the supply
wires and ceiling support cable pass
through the hole in the center of the
ceiling bracket.
NOTE: SUPPLY WIRES HAVE BEEN
OMITTED FROM DIAGRAM.
WARNING
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before hanging.
3. Twist the ceiling bracket
counterclockwise and lift out of the
ceiling canopy.
6. Route wires and safety cable through
the screw trim cover ring and ceiling
canopy.
NOTE: SUPPLY WIRES HAVE BEEN
OMITTED FROM DIAGRAM.
Ceiling
Bracket
9. Lift your fan motor assembly and hang
it from the ceiling bracket hook through
one of the two screw holes in the canopy
lip. Do not use the grooved slots.
Hook