Fanimation CCK8534 Instrucciones De Instalación página 3

Attach Safety
Cable To Ceiling
Support Cable
10. Attach the safety cable to ceiling
support cable. Slide cable clamp and
washer onto safety cable (from fan). Place
the end of cable through the loop of
ceiling support cable. Pull as much cable
through loop as possible. Feed end of
cable into clamp hole and firmly tighten
screw. You can now proceed with the
electrical wiring of your fan.
Connect your fan's wiring according to
Kute or Kute5 ceiling fan owners manual.
If you have misplaced your owners
manual one can be downloaded at
fanimation.com or contact a licensed
electrician to complete the wiring of your
fan.
13. Push the screw trim cover ring up to
conceal the screws, such that the
mounting tabs seat into the dimpled
grooves in the ceiling canopy midway
between the screws.
Ceiling
Bracket
Screw
Slot
11. Lift the fan off the bracket hook and
mount your fan by sliding the ceiling
canopy over the mounting bracket with
the two loosened screws going into the
" L " slots in the canopy. Be sure all wiring
and receiver are tucked into the ceiling
canopy and are not pinched. Once the
canopy is flush with your ceiling, turn
clockwise to seat the screws into the
keyed portion of the slot and tighten the
screws.
NOTE: SUPPLY WIRES HAVE BEEN
OMITTED FROM DIAGRAM.
Installation of your close-to-ceiling kit is
Ceiling
complete. Reference your owners manual
Canopy
for any additional assembly steps required
for Kute or Kute5 ceiling fan.
Dimpled
Groove
Mounting
Tabs (4)
Screw Trim
Cover Ring
10983 Bennett Parkway
(888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
WWW.FANIMATION.COM
Zionsville, IN 46077
12. Install the remaining two screws
removed in Step 2 to secure the ceiling
canopy to the ceiling bracket.
Copyright 2022 Fanimation
Ceiling
Bracket
Ceiling
Canopy
2022/03 V.01