A Starter Key Switch; B Throttle Control Lever; C Parking Brake Switch; D Cutter Switch (Pto) - Jacobsen F305 Manual De Seguridad, Funcionamiento Y Mantenimiento

CONTROLS 6

6.2.A STARTER KEY SWITCH_______________________________________________

The Starter Key (A) must be turned clockwise to the 'start' position to start the engine.
After starting, the key must be released and allowed to return automatically to the 'on'
position for normal running.
NOTE:The glow plugs will auto pre-heat depending on the coolant temperature before
cranking begins.
6.2.B THROTTLE CONTROL ROTARY ________________________________________
Rotate the Throttle Control to the right to increase the engine speed and towards the left
to decrease the engine speed.
NOTE: Operate the machine with the engine at full speed.
6.2.C PARK BRAKE _______________________________________________________
When the engine is running the Park Brake is applied by sliding back the
orange button on the rocker and depressing the switch on the control panel.
When the engine is switched off the Park Brake is automatically applied.
To release the parking brake depress the opposite end of the rocker switch.
DO NOT apply the brake when the machine is moving.
When the Park Brake is applied, the parking symbol is shown on the visual display.
When the machine is in motion, DO NOT apply the brake.

6.2.D CUTTER SWITCH (PTO) ______________________________________________

To commence cutting ensure speed limiter is in mow position and
the units have been lowered.
Push bottom of the rocker switch and move joystick towards the
lower position.
To stop cutter unit rotation push top of rocker switch.
Cutting units stop rotating automatically when raised or the oper-
ator leaves the seat.
en-27