Publicidad
Preparation
Mounting accessories
• Move the quick release lever forward (A) to the open
A
position to release the clamping screw clamp.
• Remove the set screw (B).
• Install the desired accessory by inserting it into the
accessories holder (C) matching its slots with the notches in
the tool holder (D).
• Replace the set screw and hold it in place momentarily to
keep the accessory secure.
• Place the quick release lever in its original position to secure
the accessory (E).
B
D
C
E
Sanding attachment assembly
• The sanding sheet backing mounts just like any other
accessory.
• It has a hook and loop attachment system to receive the
included sanding sheets.
• Align the sanding sheet and press it by hand onto the
sanding plate .
• Press the power tool firmly with the sanding sheet
against a flat surface and briefly turn the power tool on.
This will promote good adhesion and help prevent
premature wear.
• To change the sanding sheet, simply detach the old
sanding sheet, dust off the backing pad, if necessary, and
press the new sanding sheet into the correct position.
• For maximum abrasive usage, rotate the pad 120 degrees
as the abrasive tip wears.
Use coarse grit sandpaper for rough surfaces, medium grit
for smooth surfaces and fine grit for finish surfaces. If
necessary, test with scrap material first.
• Excessive force will reduce the efficiency of the work and
cause motor overload.
7
ENGLISH
Publicidad
