Publicidad
Operation
Operation
• Accessories last longer if wear is evenly distributed.
• Make cuts or sand with a steady motion and light pressure. A strong pressure does not increase the speed of the work,
instead the accessory wears faster.
• If the tool gets too hot, especially when used at low speed, set the speed to maximum and run without load for 2-3
minutes to cool down the motor. Avoid prolonged use at very low speeds.
• Make sure cutting accessories are always sharp.
• Always make sure the workpiece is securely clamped or fastened to prevent it from moving during cutting or sanding
work. Any movement of the material can affect the quality of the cut or sanding finish.
Cualquier movimiento del material puede afectar a la calidad del corte o del acabado de lijado.
• Replacing the accessory every time it shows wear will maintain optimum working efficiency.
Correct and incorrect uses
CORRECT: Sand moving
smoothly back and forth,
let the weight of the tool do
the work .
INCORRECT: Avoid tilting
the pad. Always sand with
the pad parallel to the
surface.
CORRECT: When sanding
corners, keep the edge of
the pad in line with the
corner profile and move
gently back and forth.
INCORRECT: To get a good
result when sanding
corners and angles, avoid
working with the tip of the
pad pointing toward the
profile.
CORRECT: When cutting
move smoothly back and
forth without forcing the
blade by applying only
enough force to guide the
tool.
INCORRECT: Do not force
or tilt the tool while cutting,
otherwise it may bind or
damage.
CORRECT: Make sure the
flexible attachment blade
stays flexed during work .
INCORRECT: Failure to
keep accessory pliable
could result in set screw
contacting work surface.
ENGLISH
9
Publicidad
