Sebson HD GS403 Manual De Instrucciones página 12

Installation (Fig.6) :
1: Dowel
2. Mounting base
3. Holes for screws for fixing
4: Screw
5: Retainer of the bayonet connection
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!
Attention
: The device is only ready for operation if the case is properly attached to the mounting base. Otherwise
the battery is deactivated and the device is not ready for use.
Install the heat detector in the middle of the room if possible. Observe a minimum distance of 0.5m from the side wall
and 0.6m from the corner of the room, as well as a maximum installation height of 6m (see Fig.5).
▪
Remove the mounting plate located on the back of the housing by turning it counterclockwise.
▪
Select an easily accessible installation location, as the heat detector must be checked weekly for proper
functioning!
▪
Hold the mounting base to the position on the ceiling where you want to attach the unit. Then draw the holes
for the drill holes on the ceiling with a pencil.
▪
Then drill two holes (Ø 6mm). Take the two plugs included in the delivery and insert them into the drilled
holes.
▪
Screw the mounting base to the ceiling. The screws are included in the delivery.
▪
Attach the housing to the mounting base by turning it clockwise until it clicks into place.
Behavior in case of fire:
In case of fire, go outside immediately and call the fire brigade for help! Do not waste time by putting on clothes or
carrying personal belongings. Inhaling the dangerous smoke gas will cause severe damage to your body, which can
lead to unconsciousness and subsequent death!
Further fire protection measures:
▪
Creation of an escape plan
▪
Fire extinguisher and fire blanket
▪
Operate open fire e.g. lighted candles only under adult supervision
▪
Use electrical devices with automatic switch-off
Technical Data:
Operating voltage:
Battery type:
Energy consumption:
Alarm Volume:
Heat sensitivity:
Humidity:
3V DC
CR123A Pairdeer 3V 1.500mAh/ Li-MnO2
< 5μA (Stand-By), 160mA (Alarm)
≥ 85dB (A) within 3m
54°-70°C
10-85%
12