EINHELL GE-CT 18/30 Li Manual De Instrucciones página 15

5.2 Adjusting the additional handle (Fig. 5)
Pull the release (Item 6) in the direction of the
arrow and tilt the additional handle. There are 5
working positions and one storage position in
which the additional handle can latch. Operation
is permitted only when the additional handle is
latched in place.
5.3 Height adjustment (Fig. 6)
Pull the release (Item 4) and set the required
working height on the telescopic tube. You will
hear an audible click when the telescopic tube
latches in place. Operation is permitted only when
the telescopic tube is latched in place.
5.4 Adjusting the angle of tilt of the motor
head (Fig. 7)
Press the button for adjusting the angle of tilt
(Item 8). Now you can set the motor head to
the required angle of tilt. To fi x the angle of tilt,
release the button and allow the handle to lock
into position. Four diff erent locking angles are
possible.
Warning!
Risk of injury!
If the angle of tilt of the motor head is incorrectly
set, you could injure yourself or the string trimmer
could become damaged.
•
Use the string trimmer only when the motor
head and the button are latched in one of the
four positions for the angle of tilt and when the
motor head is securely seated.
•
Do not use the string trimmer if the motor
head is not latched in place.
5.5 Using the edge guide (Fig. 7)
There are 2 locking points (minimum / maximum
edge guide length). To change the position of the
edge guide (Item 12) after it has latched in place,
pull or and push it out of the lock.
5.6 Fitting the battery (Fig. 8-9)
Press the push-lock button (22) of the
rechargeable battery and push the rechargeable
battery into the mount provided. Make sure that
the push-lock button engages properly! To remove
the battery, proceed in reverse order!
Danger!
Start up the equipment only when it is fully
assembled.
Anl_GE-CT_18-30_Li_USA_SPK7.indb 15 Anl_GE-CT_18-30_Li_USA_SPK7.indb 15
EN
6. Operation
6.1 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found in
the original operating instructions for your charger.
6.2 Battery capacity indicator (Fig. 8)
Press the battery capacity indicator switch (23).
The battery capacity indicator (24) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
The string trimmer has a semi-automatic line
extension system. Each time you activate the
semi-automatic line extension system, the line
is automatically extended to ensure that you
can cut your lawn with the perfect cutting width
at all times. To extend the line, run the motor
and tap the line spool on the ground. This will
automatically extend the line. The blade on the
safety guard will cut the line to the appropriate
length. Please note that the more often you
activate the semi-automatic line extension
system, the more the line will wear.
Note: If the line is too long when you use the
equipment for the fi rst time, the surplus end of it
will be cut by the blade on the safety guard.
If the line is too short when you start the
equipment for the fi rst time, press the knob on the
line spool and pull the line hard. When you then
start the machine for the fi rst time the line will be
cut to the perfect length automatically.
Caution! Bits of the line catapulted out into
the surroundings could cause injuries!
- 15 -
12.12.2022 13:40:09 12.12.2022 13:40:09