Publicidad
Step 6
Separate the EXTENSION SLIDES (II) from the
å
EXTENSION RAILS (HH) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (HH) to the EXTENSON
å
BLOCKS on the RIGHT END (A) and RIGHT UPRIGHT (C).
Use four GOLD 5/16" FLAT HEAD SCREWS (RRR).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Notched edge
Open end
www.sauder.com/services
II
Push the black lever in and pull the SLIDE from the RAIL.
RRR
HH
C
408291
HH
Notched edge
HH
A
Open end
Page 11
Publicidad
