Step 17
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (L) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Peel the FELT DISC from the FELT DISC CARD (HHH).
å
Stick a FELT DISC on the DOOR where it comes in
contact with the UPRIGHT (D).
Fasten a PULL (CCC) to the DOOR (L). Use two BLACK 1"
å
PAN HEAD SCREWS (NNN).
See the next step for adjustments.
å
CCC
NNN
BLACK 1" PAN HEAD SCREW
(2 used in this step)
Page 22
B
L
HHH
D
408291
Stop
Mounting
screw
Hinge
www.sauder.com/services