Publicidad
Step 15
Carefully turn your unit over onto its front edges. Lay the
å
BACKS (K and O) over your unit.
Make equal margins along all four edges of the BACKS (K
å
and O). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (K and O) to your unit using the NAILS (SSS).
å
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Tighten the TWIST-LOCK® FASTENERS in the MODESTY
å
PANEL (G) at this time.
Page 20
Cut-out for lifting the desk
K
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Tighten two
TWIST-LOCK®
FASTENERS.
G
O
408291
Caution
SSS
NAIL
(35 used in this step)
Cut-out for lifting the desk
www.sauder.com/services
Publicidad
