Publicidad
Step 20
1
D87
T
Groove
Insert the LARGE DRAWER SIDES (D87 and D88)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (T).
3
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D708) inserts into the groove of the LARGE DRAWER BACK (D78).
å
Repeat this step for the smaller drawers using parts (CC, D18, D19, D74, and D707) and parts (V, D10, D11, D86 and D707).
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
VIEW THE T-LOCK BOX VIDEO
2
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D708) into the
å
grooves in the LARGE DRAWER SIDES (D87 and D88) and
LARGE DRAWER FRONT (T).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
408291
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D708
D88
T
30S
(12 used in this step)
Page 25
Publicidad
