Beper 90.350 Manual De Instrucciones página 14

Steam cleaner Use instructions
Floor brush:
This accessory is used with extensions, and is provided with floor cloth. It is fitted with effective re-
taining spring which can hold any type of cloth washable in the washing machine, to effectively and
quickly clean all surfaces.
To attach the cloth, place it on the brush then pull the edges of the cloth one by one under the re-
taining springs.
REFILLING THE BOILER WHILE THE CLEANER IS IN USE
When the water has been used up by pressing button, no more steam will be supplied.
a) switch off the appliance by operating switch;
b) remove the plug from the power socket;
c) press button to expel any residual steam; this way the cleaner can be used for a while after it is
turned off.
d) slowly unscrew the safety cap and wait a few seconds until no steam can be heard escaping
before unscrewing the cap completely;
WAIT A FEW MINUTES BEFORE ADDING FRESH WATER TO THE BOILER.
e) refill with water, adding it slowly at first to avoid puffs of steam.
f) screw the safety cap on again tightly;
g) plug the power supply cable in again;
h) press the ON/OFF switch.
CLEANING AND MAINTENANCE
Unplug the appliance before performing any operation. Before storing or cleaning the appliance,
allow it to cool down. To keep the appliance in full working order for many years, simply rinse out
the boiler once a month with water in order to remove the lime scale deposits. Do not use vinegar
or other decalcifiers.
AFTER USE
After steam cleaning, switch off the boiler and expel any remaining steam by pressing the button .
It is advisable to wait for at least an hour before opening the boiler and emptying it carefully.
Wind the flexible tube hose around the cleaner body and place the pistol onto the handle
TECHNICAL DATA
Tank capacity 1.2 litres
Steam flow: 40g/min
Power 1500 watt
Power supply 220/240V ~ 50 Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
14