Publicidad
Idiomas disponibles
Idiomas disponibles
3-2 Date and Time Settings
Make sure you set the time and before you begin you begin recording, to "Protect Your Side of The Story".
1. Press the MENU button to access your camera's setting menu. Press the Menu button again to go into
System settings, then select "Date Input" to begin date and time settings.
2. Press the UP/Down buttons on the Dash Cam to make changes to date or time, then press the OK
button to confirm.
3-3 Recording Mode
3-3-1 Continuous Recording
By default, the system will automatically begin with continuous recording a few seconds after start-
up. The Recording icon
light should flash, indicating that recording is in progress. You can manually stop the recording by
pressing the OK button. Pressing the OK button again will restart continuous recording.
The recorded video will be saved under the "DCIM" folder on your Dash Cam's TF memory card.
Notes:
•
In Recording standby mode, press the Menu button to pop up video recording settings menu.
You can enable or disable the voice recording along with video, and set recording time for
video clip: 1 mins / 3 mins / 5 mins/ 10 mins.
•
When the memory card is full, new videos will record over the oldest videos.
•
If you do not want to automatically record over old content, you can turn auto-record off in
Settings and the device will stop recording once the TF card is full.
3-3-2 Manual Recording
In addition to recording accidents, you can also press the OK button on the Dash Cam to initiate
manual recording mode to capture scenery and/or places while driving.
will appear on the upper left corner of the display screen. The blue
7 EN
Publicidad
