Changing the battery
Changing the battery
A change of batteries becomes necessary when "Lo" appears on the display, or when
nothing at all is displayed.
When changing the battery, bear the following in mind:
The data that has been ascertained and entered up to that point remains stored
on the scales.
Only use the type of battery that is specified in the "Technical data".
Pay attention to the correct polarity (+/-) when inserting the battery.
The plus pole (+) must point upwards.
Dispose of the old battery in an environmentally responsible way (see "Disposal").
Cleaning
NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Never use harsh, scouring or abrasive cleaning agents or the like to
clean the scale. Otherwise, the surface could be scratched.
1. Wipe the scale as needed with a slightly damp soft cloth.
2. Disinfect the weighing surface and the sensors from time to time using a suitable
disinfecting agent (available at specialist retailers and pharmacies).
Fault/Remedy
Fault
No function
The scale appears to be displaying
wrong weighing results
"Lo" is shown on the display
26
Possible cause
Are the batteries empty or inserted the
wrong way around?
Is the scale located on a firm, even surface?
Is a device that can cause electromagnetic
disturbances located in the vicinity of the
scale?
Remove the batteries from the scale and
wait a moment. Reinsert the batteries. The
data stored until then are retained.
The batteries are empty, see "Changing the
battery".
BA 914 body analysis scale