RIB MINI WIRELESS Manual Del Usuario página 15

4.3 Parameter reset to factory defaults
This deletes all parameters (position automatic opening, alarms) without erasing all transmitters.
To restore the parameters to the factory default is sufficient to do the following:
1. Close the awning.
2. Press and hold for almost 7 seconds the learning key until the red LED alarm / learning flashes rapidly.
3. Release the button.
The red LED stops blinking. The restoration has been performed.
4.4 Resetting the memory and reset to factory settings
At any time it's possible to reset the factory settings by resetting the card. This also leads to the cancellation of all the remote
controls, sensors and automatic opening position. To reset the board is sufficient to do the following:
1. Remove power to the control unit
2. Press and hold the learning key while the control unit is powered up. The three LEDs red, green and yellow lights flash once
and after that they stay on.
3. Hold down the key until the red LED turns off.
4. Release the key.
After this operation every remote control and any wireless sensor must be programmed again.
5
USING A TRANSMITTER
By closed awning, pressing the key "a" of opening, the awning will roll down.
To stop the rolling down press the reverse key "b" or the "c" STOP.
A subsequent pression of "b" will reverse the rolling motion.
a c b
Opening Stop Closing
Warning: keys functions are only valid with the DIP4 in OFF position (see 6.2.4)
15