Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Maintenance
• Clean the helmet with mild soap in lukewarm water.
• Clean the welding filter with a clean, lint-free tissue or cloth.
• Do not immerse in water.
Troubleshooting
Irregular
darkening
Auto-darkening
flickers or does
not darken
Poor vision
10
1. When assembling the
headgear to the helmet, if one
bolt is on the upside of the
hole, another bolt is on the
downside of the hole.
1. Front cover lens is soiled.
2. Photo sensors are dirty.
1. The cover lens and filter
cartridges are not clean.
2. Lighting conditions are too
low.
3. The shade number is not
correct.
4. Battery is low.
5. Replace battery.
1. Adjust the headband
bolts on both sides to
assure they are both up or
both down on the hole.
1. Clean or replace the front
cover lens.
2. Wipe clean with a soft,
lint-free cloth.
1. Make certain the cover
lens and filter cartridges
are clean.
2. Make sure that there is
enough light to activate the
auto-darkening lens by
holding it to the light and
switching between the
grinding mode and welding
mode.
3. Make certain the shade
number is correct and
properly adjusted.
4. Replace both batteries.
Make sure the polarity of
the batteries is correct
when installing them.
5. Pull out the covers on the
automatic filter and replace
both CR2032 batteries.
After batteries have been
replaced, insert the covers
back on the automatic filter.
Publicidad
