Samoa DF30 Manual De Operación Y Mantenimiento página 103

5. The display screen again shows all the segments
of the display followed by all the switched-off
segments and finally shows the display page
where the reset Reset Total is shown.
Dispensing with flow rate mode display
It is possible to dispense fluids, displaying
at the same time:
1. The dispensed partial.
2. The Flow Rate in [Partial Unit / minute] as
shown on the following display page:
Procedure for entering this mode:
1. Wait for the Remote Display to go to
Standby, meaning the display screen shows
Total only.
2. Quickly press the CAL key.
3. Start dispensing.
The flow rate is updated every 0.7 seconds.
Consequently, the display could be relatively
unstable at lower flow rates. The higher the flow
rate, the more stable the displayed value.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Operating mode
Daily use
ATTENTION: The flow rate is measured with
reference to the unit of measurement of the
Partial. For this reason, in case of the unit of
measurement of the Partial and Total being
different, as in the example shown below, it
should be remembered that the indicated flow
rate relates to the unit of measurement of the
partial. In the example shown, the flow rate is
expressed in Qts/min.
The word "Gal" remaining alongside the flow rate
refers to the register of the Totals (Reset or NON
Reset) which are again displayed when exiting
from the flow rate reading mode.
IMPORTANT: Even though in this mode they are
not displayed, both the Reset Total and the
General Total (Total) increase. Their value can be
checked after dispensing has terminated, returning
to "Normal" mode, by quickly pressing CAL.
Partial reset (flow rate mode)
To reset the Partial Register, finish dispensing and
wait for the Remote Display to show a Flow Rate
of 0.0 as indicated in the illustration then quickly
press RESET.
R. 01/16 836 828
5