Descargar Imprimir esta página

Louisiana Grills FOUNDERS PREMIER Serie Guía De Montaje página 3

Parrilla y ahumador de pellets de madera
Ocultar thumbs Ver también para FOUNDERS PREMIER Serie:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
ASSEMBLY PREPARATION
MAJOR CAUSES OF APPLIANCE FIRES ARE A RESULT OF POOR MAINTENANCE AND A FAILURE TO MAINTAIN REQUIRED
CLEARANCE TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS PRODUCT BE USED ONLY IN
ACCORDANCE WITH THE FOLLOWING INSTRUCTIONS.
Parts are located throughout the shipping carton, including below the grill. Inspect the grill, parts, and hardware blister pack after removing from the protective
shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then review and inspect all parts by referencing the parts
list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact Customer Service for parts: Monday
through Sunday, 4 a.m. - 8 p.m. PST (EN/FR/ES).
IMPORTANT: TO EASE INSTALLATION, USING TWO PEOPLE IS HELPFUL (BUT NOT NECESSARY) WHEN ASSEMBLING THIS UNIT.
Tools required for assembly: screwdriver. Tool not included.
ASSEMBLY INSTRUCTIONS
IMPORTANT: IT IS ADVISED TO READ EACH STEP ENTIRELY BEFORE STARTING ASSEMBLY ON INSTRUCTIONS. DO NOT
TIGHTEN SCREWS COMPLETELY UNTIL ALL SCREWS FOR THAT STEP HAVE BEEN INSTALLED. HARDWARE COMBINATION
INVOLVING A LOCKING WASHER AND WASHER SHOULD BE INSTALLED WITH THE LOCKING WASHER CLOSEST TO THE
HEAD OF THE SCREW.
A
1
7
17
16
B
1
17
16
C
1
16
17
D
1
16
WWW.LOUISIANA-GRILLS.COM | TOLL-FREE: 1.877.303.3134
FITTING LEGS TO THE BARREL
PARTS REQUIRED:
1
x
Main Barrel (#7)
2
x
Support Leg A (#16)
2
x
Support Leg B (#17)
16
x
Screw (#A)
16
x
Washer (#B)
16
x
Locking Washer (#C)
INSTALLATION:
Place a piece of cardboard on the floor to prevent scratching the unit. Lay the Main
Barrel on its side, hopper end pointed upward, on the cardboard.
NOTE: FASTEN THE SCREWS OF THE SUPPORT LEGS ONLY HALF-WAY TO ALLOW EASIER
INSTALLATION OF BOTTOM SHELF IN NEXT STEP.
Mount Support Leg A to the floor end of the Main Barrel using one Washer, Locking
Washer, and Screw from the inside of the main barrel. Note illustration 1A.
Next, from inside the Main Barrel skirt, install three Washers, Locking Washers, and
Screws into the same support leg. Repeat installation for Support Leg B on the floor
end of the Main Barrel. Note illustration 1B.
Repeat the same installation for Support Leg A and B on the hopper end of the Main
Barrel. Note illustrations 1C and 1D.
17
3
www.louisiana- grills .com

Publicidad

loading

Este manual también es adecuado para:

Founders premier lg0800fp10630