Louisiana Grills FOUNDERS PREMIER Serie Guía De Montaje página 6

6
A
9
B
9
10
2
www.louisiana- grills .com
4
3
1
2
INSTALLING THE SEAR STATION COMPONENTS
PARTS REQUIRED:
1 x Flame Broiler Slider (#3)
1 x Flame Broiler Main Plate (#4)
INSTALLATION:
NOTE: SOME OF THE COOKING COMPONENTS MAY BE LIGHTLY COATED WITH OIL TO AVOID
RUSTING WHEN SHIPPED.
• Insert the Flame Broiler Main Plate into the grill barrel. Rest the Flame Broiler Main
Plate on the built-in ledge, right side first, of the Main Barrel that directs grease
towards the Grease Bucket. Slide the entire piece to the left side, and the Main Plate
will lock into the raised tab above the Burn Grate. Note illustration 9A.
IMPORTANT: IF THE MAIN PLATE IS RESTING ON THE BASE OF THE BARREL, IT IS INSTALLED
INCORRECTLY. THE FLAME BROILER MAIN PLATE IS USED TO DISTRIBUTE THE HEAT EVENLY.
POOR INSTALLATION OF THIS PART MAY RESULT IN DAMAGE TO YOUR MAIN GRILL BARREL.
• Place the Flame Broiler Slider on top of the Flame Broiler Main Plate. Note illustration
9B. Two important features to check:
1. Ensure the small anchor pin on the right side of the Flame Broiler Slider goes
into the small pin hole of the Flame Broiler Main Plate.
2. Ensure the large control pin underneath the Flame Broiler Slider goes into the
large opening of the Flame Broiler Main Plate, sitting over-top of the sear station
control rod.
IMPORTANT: AFTER THE FLAME BROILER SLIDER IS PROPERLY INSTALLED, THE SEAR
STATION SWITCH CAN BE ADJUSTED BY THE BY THE CONTROL KNOB ON THE HOPPER. IF
THE SEAR STATION SWITCH DOES NOT FUNCTION CORRECTLY, RE-INSTALL THE FLAME
BROILER SLIDER TO ENSURE THE LARGE CONTROL PIN IS PLACED OVER-TOP THE RIDGE OF
THE ADJUSTABLE CONTROL ROD OF THE SEAR STATION SWITCH.
NOTE: WHEN THE FLAME BROILER SLIDER IS OPEN, AND DIRECT FLAME IS USED WHILE
COOKING, DO NOT LEAVE THE GRILL UNATTENDED FOR ANY PERIOD OF TIME.
INSTALLING THE COOKING COMPONENTS
PARTS REQUIRED:
1 x Upper Cooking Rack (#1)
2 x Cooking Grids (#2)
INSTALLATION:
• Place the two Cooking Grids side-by-side on the lower grid ledges inside the Main Grill.
• Following, place the Upper Cooking Rack on the upper ledge inside the Main Grill. The
Upper Cooking Rack will lock into place.
IMPORTANT: TO MAINTAIN OPTIMAL SEARING AND GRILLING PERFORMANCE OF YOUR
COOKING GRIDS, REGULAR CARE AND MAINTENANCE IS REQUIRED.