Kohler K-72218 Guía De Instalación Y Cuidado página 6

Instale la grifería (cont.)
Gire el anillo de manera que los tornillos se alineen al frente y atrás.
Utilice un destornillador Phillips para apretar los tornillos.
2.
Connect the Hoses
Ø 3" (76 mm)
Min/Min/Mín
Supply Hose
Tuyau
d'alimentation
Manguera
de suministro
CAUTION: Risk of restricted waterflow and product damage. Supply hoses must
not be taut, kinked, or twisted during installation. If the supply hoses must be coiled,
maintain an inside diameter of 3" (78 mm).
Connect the Supplies
Assemble the outlet hose to the faucet.
Connect and tighten the supply hoses to the supply stops.
Place a bucket under the outlet hose.
Turn on the water supplies.
Flush hot and cold water into a bucket for one minute to remove any debris.
Connect the Spray Hose
NOTICE: The weight must be installed onto the spray hose to act as a pull stop and
prevent kinking damage.
Slide the weight, then the clamp onto the spray hose.
TIP: Use a pliers to expand the clamp over the hose end.
1186051-2-B
Solenoid
Solénoïde
Solenoide
Outlet Hose
Tuyau de sortie
Manguera de salida
Clamp
Collier
Abrazadera
Weight
Poids
Pesa
6 Kohler Co.