INSTALLATION
Safety
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
Property damage
!
Observe the maximum inlet temperature. Higher tem-
peratures may damage the appliance. You can limit the
maximum inlet temperature by installing a central ther-
mostatic valve.
WARNING Electrocution
This appliance contains capacitors which are discharged
when disconnected from the power supply. The capacitor
discharge voltage may briefly exceed > 34 V DC.
www.stiebel-eltron.com
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
The electrical resistivity of the water must not fall below that stated
on the type plate. In a linked water network, factor in the lowest
electrical resistance of the water (see chapter "Installation / Spec-
ification / Data table"). Your water supply utility will advise you of
the electrical resistivity or conductivity of the water in your area.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- Strainer in the cold water supply
- Special aerator
- Connection hose 3/8, 500 mm long, with gaskets*
- Tee 3/8*
- Company logo for oversink installation
*for the connection as pressure-tested appliance
EIL Premium |
9